EX2300-24T-TAA Juniper EX2300 Series Ethernet Switches

EX2300-24T-TAA Hardware Identity

EX2300-24T-TAA is a Juniper EX2300 fixed-configuration Ethernet switch. Its verified hardware profile is 24 10/100/1000BASE-T access ports; no PoE on access ports. The complete code carries TAA procurement-qualified order suffix. Preserve every suffix on the quote, carton and asset record.

Port and power boundary

no PoE budget. The uplink configuration is four SFP/SFP+ uplinks. Optics, optional uplink modules, cables and any separately ordered power or mounting items must be reconciled in the final bill of materials.

EX2300 architecture control

EX2300 acceptance should reflect a compact access-switch design. Record the fixed power arrangement, access-port population and the exact number of SFP/SFP+ uplinks on this model. If Virtual Chassis is planned, Juniper documents a maximum of four EX2300 members and requires SFP+ rather than SFP transceivers for VCP links. Preserve member IDs, VCP optics, Junos release and recovery behavior. Do not borrow EX3400 redundant-supply or larger-chassis assumptions.

Order-form control 1

AC power acceptance requires the supported input range, regional cord, receptacle, circuit capacity and selected supply wattage to be documented. Where redundant supplies are used, place them on the intended independent circuits and test loss of one feed. Do not substitute a DC chassis or mix supply wattage or airflow. Retain supply serials, cord type and circuit labels with commissioning evidence.

Order-form control 2

Where the PID has no explicit AFI or AFO suffix, use the Juniper model table and actual FRU labels to establish the shipped airflow. Record intake and exhaust orientation before rack placement, and reject any replacement fan or supply whose airflow differs. The absence of a suffix is not permission to mix directions or to infer the pattern from another chassis.

Order-form control 3

The TAA suffix is part of the procurement identity. Keep the full PID unchanged through quote, purchase order, invoice, carton inspection and asset registration, and let the contracting authority decide eligibility. A base model, VC line or non-TAA substitute requires a new compliance review; technical equivalence alone does not preserve the purchasing requirement.

SKU-specific acceptance

Use the twenty-four-port TAA model where exact port count and contracting evidence are both recorded; do not substitute a VC or DC suffix. Use a twenty-four-port contracting schedule that pairs every intended endpoint with a port role while preserving the full TAA order code. Verify four uplink positions and reject an offered VC or DC variant unless both technical and procurement reviews are repeated. Asset registration must retain the exact suffix.

Lifecycle

Review Juniper lifecycle and supported-release information before expanding an older platform. Tie spares and new capacity to a dated migration decision.

Migration evidence

Map VLANs, routing, policy, uplinks, PoE endpoints and monitoring dependencies to the successor design. Close old serials only after service and telemetry are verified.

Airflow match

Record rack cold aisle, intake side and exhaust side. Fan modules and power supplies must use the same airflow direction; a suffix mismatch is a receiving failure.

Junos baseline

Record the approved Junos release and hardware support evidence before staging. Preserve the initial configuration, rescue state and post-upgrade validation.

Uplink plan

Map every uplink speed, optic, breakout, LAG member and peer. Optional uplink modules and transceivers must appear as separate bill-of-material lines where required.

Capacity test

Measure representative access, uplink and control-plane load after staging. Preserve errors, drops, temperature and latency rather than accepting link-up alone.

Related Juniper EX records

• EX2300-24T-DC switch record
• EX3400-48T-TAA switch record
• EX4300-32F-DC switch record

Official Juniper evidence

EX2300 system overview and model table. Verify the current hardware guide, supported Junos release and lifecycle notice at the final design date.