Fortinet FortiSwitch FS-148E 48-Port Gigabit Ethernet Access Switch

FS-148E is the non-PoE 48-port model

Fortinet FortiSwitch FS-148E is a Layer 2 secure access switch with 48 x GE RJ45 ports and 4 x GE SFP uplinks. The exact model is FS-148E, not FS-148E-POE. Buyers who require switch-supplied endpoint power must select and validate the separate PoE ordering line rather than assuming PoE from the 48-port chassis.

High-density non-PoE access

This model suits copper access designs where phones, access points or other endpoints use external power, injectors or another documented power method. Build a port schedule that records VLAN, authentication, voice, uplink and power ownership for each endpoint. The switch's non-PoE identity must remain visible in the bill of materials and installation plan.

Four GE SFP uplinks

The four SFP cages can support compatible Gigabit uplink transceivers selected for the required medium, wavelength and distance. Verify each optic against the FortiSwitchOS release and peer device. Do not assume that SFP modules, fiber jumpers or copper transceivers are included with the base switch.

Controller and release validation

Fortinet lists FS-148E as a supported FortiSwitch model and documents FortiGate-managed secure access operation through FortiLink. Before deployment, confirm the intended standalone or managed topology, FortiGate model, FortiOS/FortiSwitchOS versions, feature requirements and lifecycle support.

Receiving and migration checklist

Confirm the label reads FS-148E, count 48 RJ45 and four SFP interfaces, inspect rack and power accessories, and record the installed firmware. Validate uplinks, VLANs, authentication and representative endpoint traffic before migrating a full access block. Use Fortinet's model-specific diagnostic guidance because some E-series platforms have cable-test limitations.

Fortinet official FortiSwitch Secure Access data sheet; Fortinet official supported-model list; Fortinet official cable-diagnostics guidance.