H3C EWP-WA5320H-FIT WA5320H Wall-Plate Access Point

Plan the wall-box replacement

The WA5320H model is designed for an 86 mm wall-box installation. Its 802.11ac Wave 2 design has two bands and four streams in total. Check the existing box, cable access and room layout before approving a replacement; a wall-plate AP is not a ceiling-mounted controller or a general-purpose switch.

Keep pass-through wiring distinct from Ethernet switching

The H3C installation guide identifies the pass-through connectors as RJ-45. These are separate from the rear Uplink/PoE In connection and front Ethernet ports. Record the function of each existing cable so that telephone or other pass-through wiring is not mistaken for a switched AP port.

Verify power and controller preparation

H3C documents 802.3af and 802.3at PoE input. In FIT mode configuration is performed on the wireless controller; confirm the controller release, registration and required AP entitlement before installation. The model guide also describes cloud operation, but a mode change must be checked against the installed software and commercial configuration.

Confirm the exact supplied article

The linked references document the WA5320H model. Ask for the full manufacturer article and regional suffix corresponding to this listing on the quotation, together with condition and mounting items. Do not substitute WA5320H-EPON, WiNet or LI variants without verifying their different hardware and deployment requirements.

Official model references: WA5320H specifications; WA5320H installation guide 6W105.