N3024ET-ON Dell N3000 Series 24x1G RJ-45/2x1G SFP Combo Switches

Specify the 24-port copper member of N3000E-ON

Dell N3024ET-ON is a rack switch with twenty-four 10/100/1000BASE-T RJ45 network ports. The exact ET model appears in the N3000E-ON hardware guide; it should not be confused with N3024EF-ON, whose access connections use SFP media, or the EP power-delivery variant. Match the model suffix to the required endpoint connections.

Fit the chassis to the installation space

Dell lists the N3024ET-ON chassis as 43.5 mm high, 434 mm wide and 407 mm deep. Its approximate weight without modules is 6 kg. These are chassis planning figures: allow additional room for cable bends and access to the rear connections, and confirm the mounting hardware supplied with the offered unit.

Distinguish the power supply rating from consumption

The official model table gives a 200 W power-supply rating for N3024ET-ON and separately lists maximum power consumption of 52.8 W. The two numbers describe different quantities. Use the published consumption figure for initial electrical planning and confirm the actual fitted power configuration before ordering; the short model name is not a complete bill of materials.

Prepare the copper links before commissioning

The hardware guide specifies auto-negotiation for the RJ45 access interfaces and full-duplex switch operation. Check the attached equipment and copper cabling rather than assuming every endpoint will negotiate Gigabit speed. Confirm the installed network operating system, firmware compatibility and any required uplink modules in the quotation; those commercial inclusions are not established by the access-port count.

Dell N-Series hardware guide, pages 153–155 | Dell N3000E model specifications